In this article we’re going to look at how to create your own dog mask. We’ll cover the basics and then go on to look at some of the more advanced tips and tricks which you can use.

If you have a dog that likes to bark, and particularly if your dog loves to play in the backyard and other regions of the home, you will need to get them some special dog protection.

Paper Plate 3d Dog Mask DIY Materials: This is the first part of the set-up which will look a little scary at first, but it’s actually quite straightforward. All you have to do is take a cardboard cutting board and cut the cardboard into the shape of your mask. You can’t simply cut a rectangular shape out of the cardboard, so you’ll need to cut around the edge of the mask so you get something which resembles a cone. The main thing here is to be realistic with what type of paper plate that you’re using.

Then you will need to wrap the cardboard around the edges of the paper plate, making sure that there is a good seal between the two pieces so you can make certain that nothing will leak once you put the mask on. Make sure the edges are cut so that the edges aren’t sharp, as this can damage the edges of the mask.

Glue it on! The next step involves using some paint. You should spray the paint over the cardboard, making certain it runs smoothly and evenly across the whole mask. You will want to start with one side of the mask first, so that you can work your way around it before moving onto the other side. The paint needs to be slightly thicker than the cardboard, and it is best that you leave about one-fifth of an inch of paint on the edges so that it runs over the cardboard.

Don’t worry too much about the paint getting stuck into your mask. It’s easy to remove it later, and it’ll leave you with a nice finished mask to show off to everybody! It’s also a good idea to wipe away any excess paint after you’re done, so you don’t wind up with smudges or smears on your dog.

Then it is time to glue the mask on your dog’s head. First you need to make sure that you get a secure fit between the mask and your dog’s head. Once you’ve made sure that it’s secure, then you can start to glue the mask on the dog’s face. Take the piece of cardboard that’s used for the base of the mask and fold it over. Be sure that it’s quite powerful and then use your hands to secure the cardboard down in place.

dog filter mask Keep your hands out of the way and use tape to hold it in place as you repeat the procedure on the cardboard folds till you have the mask snugged firmly onto the surface of your dog. Don’t make the folds too large or else it might look messy. As soon as you’ve completed this, you can then take out the mask and then attach the cardboard ears. And attach the other part of the mask onto the dog. Make certain the ears are flat and make sure that it’s not too short or long as this will cause some problems with the mask slipping off the dog’s face.

If you’re using a dog mask as your dog protection, you’ll need to do some sanding to be sure that it is secure on your dog. You can do this by sanding off any excess paper that may have been removed from your mask.